Saturday, October 25, 2014
Installation Tips

1. Prepare the surface for installation. Make sure to wipe clean with water soaked towel and dry the area out. Wait for a few minutes to allow any residual water to evaporate.

2. Prepare the sticker for installation by removing a perimeter cutout from the sticker.

3. Gently peel the sticker off the backing about 1/2 to 1 inch.

4. Apply detached segment to the surface.

5. Peel approximately half of the backing while having sticker stretched.
Remember, backing will keep sticker flat and will help you to control the application.

6. Apply the sticker by pressing your hand against the surface. It is advisable to use a squeegee or a credit card to assure adequate pressure for adhesive to properly attach to the surface.

Repeat step 5

Repeat step 6

7. Pull off the backing completely and finish installation.

8. Enjoy!

Occasional air bubbles or wrinkles will form during the process. Do not panic; simply apply pressure and run your finger over them. Adequate dull pressure will facilitate controlled escape of the air bubbles. If an air bubble is still trapped under the sticker, please use a sawing needle or safety pin to puncture the bubble in one spot and gently press the air out.